Rail King Y6b 2-8-8-2 Operations Instructions download pdf (Page 13)

RailKing Y6b 2-8-8-2 Steam Engine

the smoke unit inspection cover from the locomotive’s body (see Fig. 6

). After

removing the chassis and inspection cover screws, lift the inspection plate

away and inspect the wick. If it is darkly discolored and hard, it should be

replaced.

You can obtain replacement parts and wick replacement instructions from the

M.T.H. Parts Department.

Locomotive and Tender Light Bulb Replacement

To replace the light bulb in the locomotive, follow these instructions and see

the diagrams below:

Remove the locomotive boiler from its chassis as shown in Figure

3. Once the

body has been removed, rotate the headlight bulb counter-clockwise as seen in

Figure

7 to remove.

To replace the fire box light, unplug the wires from its harness, push the bulb

down through the bracket, replace and reassemble.

To replace the light in the lantern on the front of the engine, first remove the

boiler from its chassis, unplug the wire from its harness, unscrew the lantern

from the front of the engine, and pull the wires from the lantern casing.

Replace the light and reassemble.

To replace the light in the tender, unscrew the six screws holding the tender

shell on. Unplug the wires from its harness and replace the bulb, reassemble.

You can obtain replacement bulbs directly from the M.T.H. Parts Department.

HeadLight

Fire Box Light

Figure 7. Replacing the Headlight

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Rail King Y6b 2-8-8-2 Operations Instructions Page 13