Rail King SW-8 Operations Instructions download pdf (Page 29)

RailKing SW 8-9 Operating Manual

FYS PROBLEMS REMEDY

The FYS feature does not begin even after stopping

the engine and hearing the brake sounds.

The power was not turned back on once the engine

enter the neutral state thus disabling FYS.The

transformer throttle was interrupted too quickly in

neutral thus disabling FYS. Leave the throttle on in

neutral until after the FYS arrival message plays.

The FYS sound effects occasionally repeat

themselves.

ProtoSounds has a built--in random number generator

that randomly selects each sound clip to play.

Because there are only a total of 8 sound clips

available in each FYS event, it is probable that a

sound can occasionally be repeated one or more

times.

Once in FYS, the engine never goes in reverse.

So that the passenger station sound effects and

operation is as realistic as possible, ProtoSounds

disables the reverse unit state whenever FYS is

enabled. This way the engine never goes into reverse

as the operator cycles through the various FYS

events.

When the engine enters FYS event 5, the bell

automatically comes on.

FYS has a built--in command to turn on the bell when

the system enters Event 5. After approximately 15

rings of the bell, it automatically will turn off.

Whenever FYS is enabled, pressing the whistle and

bell buttons has no affect.

Because FYS must control various effects in each FYS

event, the bell and whistle functions are disabled until

either the FYS events have been completed, or the

engine is shut down for 3 or more seconds.

I can’t get FYS to begin when the engine is stopped in

the neutral position.

It is possible that FYS was never enabled or has been

disabled. Try reactivating the feature by holding down

the bell button for three or more seconds.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Rail King SW-8 Operations Instructions Page 29