Rail King 6-8-6 Steam Turbine Engine Operations Instructions download pdf (Page 7)

RailKing 6-8-6 Steam Turbine Engine

Basic Operation

Throttle up the power to your track.

Give your train enough power so that

the head light shines brightly. Then put the engine into motion by firmly

pressing the Direction button on your remote once.

Operation Buttons

Use the operation buttons on your remote as described below.

•

Throttle – To increase or decrease track voltage, and therefore train speed,

press the throttle control rocker switch. Pressing the top end of the throttle

will increase voltage and speed. Pressing the bottom end of the throttle will

decrease voltage and speed. The engine will maintain the speed you set after

you release the throttle until you press it again to change the voltage and

speed.

•

Horn/Whistle - To sound the whistle, firmly press the Horn/Whistle button.

The whistle will sound for as long as you continue to depress the button. It

will stop when you release the button.

The whistle has four different endings,

depending on whether you hold the button for less than three seconds, three

seconds, four seconds, or five seconds or longer.

•

Bell - To sound the bell, firmly press and release the Bell button. To turn the

bell off, press and release the Bell button again. The bell will continue to ring

from the time your turn it on until you press and release the button again to

turn it off.

•

Direction – Your train is programmed to start in neutral. To put the engine

into forward and then to change the direction of the train or to put it into

neutral, firmly press and release the Direction button on your remote. Just as

you must stop your car between forward and reverse, this engine will not go

directly from forward to reverse; it goes into neutral between directions. If the

train has been moving forward, the first press of the Direction button will put

the train from forward into neutral, the second press into reverse, the third

press back into neutral, and the fourth back into forward.

To prevent

accidental high-speed start-ups, this engine is programmed to restart in neutral

each time the track voltage is turned off for 25 seconds or more.

•

Emergency Stop – To drop track voltage instantly to 0, firmly press the

Emergency Stop button. All trains on the track controlled by the remote will

stop until you reapply voltage.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Rail King 6-8-6 Steam Turbine Engine Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Toys & accessories Rail King 6-8-6 Steam Turbine Engine

Related products and manuals for Unknown Sony DSC-W120